English
Nederlands
Español
Deutsch
Français1. Disconnect and reconnect the signal cable.
2. Reboot the entire system. Turn on the monitor first and the source afterwards.
3. Reset the e-screen to factory settings via the menu.
4. Turn off scaling in the display settings of the source.
Related Articles
The touch recognition of my e-screen is very slow or the touch point is in the wrong place. What can I do?
1. Calibration before first use is required. 2. Make sure that the surface of the...
I'm using a Windows 7 laptop, how do I mirror my device to the Legamaster AirServer Connect?
Unfortunately, Windows 7 does not support the Miracast protocol, and therefore ca...
The picture on my e-screen is too light or too dark. What can I do?
Adjust the brightness and contrast of the e-screen. Make sure that no direct ligh...
The touch recognition of my e-screen takes a long time. What can I do?
1. Close all active windows on your computer. 2. Restart the computer. ...