The touch recognition of my e-screen is very slow or the touch point is in the wrong place. What can I do?

1. Calibration before first use is required.

2. Make sure that the surface of the touch system is not interfered by other objects, e.g. the sleeve of a jacket.

3. Make sure that no light sources are directly shining on the surface of the board.

4. Place your stylus or finger at an angle of 90 degrees on the touch surface.

5. Don't hold the stylus too close to the tip.

6. Make sure that the inside of the frame (sensors are placed here) are clean and dust-free and are not blocked, e.g. by a magnet, so that the line of sight of the sensors is not interrupted.

7. Turn off all scaling in the display settings of the computer.

8. Calibrate the eScreen according to the Quick Setup Guide.

9. Use the resolution that can be found in the Quick Setup Guide.

 http://www.legamaster.com/downloads/software


Was this article helpful?

Disclaimer: In order to be able to provide you with help in the language of your choice, this page has been translated automatically and may contain minor grammatical inaccuracies.